• What are the hazards caused by illegal plastic electroplating processing

    What are the hazards caused by illegal plastic electroplating processing

    One is air pollution: many chemicals such as strong acids, strong bases, salts and organic solvents are used in the production of plastic electroplating, which emits a lot of toxic and harmful gases during the operation. For example, hydrofluoric acid fumes in the air, and its vapor is very corrosiv... read more

    Jun 11,2021 News
  • How to make plastic mold processing and injection molding customization

    How to make plastic mold processing and injection molding customization

    Plastic molds have developed from simple surface processing to all-round processing of surface and structural surfaces, from middle and low-speed processing to high-speed processing, and the development of processing automation control is very rapid. The clamping force must be sufficient. At present... read more

    May 31,2021 News
  • Mold manufacturers introduce common faults of stamping dies

    Mold manufacturers introduce common faults of stamping dies

    1. Die failure: Die damage is a common problem in stamping production and life, which will cause production to stop and affect the production development cycle. Therefore, we need to find out the cause of the mold failure as soon as possible and carry out scientific and reasonable maintenance. Mold ... read more

    May 27,2021 News
  • The mold manufacturer introduces how to control the cost of mold production

    The mold manufacturer introduces how to control the cost of mold production

    1. Whether the product design can be reasonable and how to develop has become a very important factor affecting the cost of the mold. If the product structure design is unreasonable, it is a very bad situation for mold companies. Make the designed products suitable for mold engineering as much as po... read more

    May 21,2021 News
  • Mold management must be standardized to ensure service life

    Mold management must be standardized to ensure service life

    1. After using the mold for a long time, the blade must be sharpened, and the surface of the blade must be demagnetized after grinding. The mold user company must make a detailed record, count its use, maintenance (lubrication, cleaning, rust prevention) and damage, and perform statistics based on t... read more

    May 14,2021 News